Yokogawa Value Series FX1000 - Manual (Page 104)

3-22
3.4 Setting Commands
IM 04L21B01-17EN
TR Sets the automatic monitor
return function
Syntax TR p1<terminator>
p1 Automatic return time limit (OFF, 1MIN,
2MIN, 5MIN, 10MIN, 20MIN, 30MIN, 1H)
Query TR?
Example Set the automatic return time limit to 5 minutes.
TR5MIN
TQ Sets a timer
When p2 is set to OFF (no timer)
Syntax TQ p1,p2<terminator>
p1 Timer number
p2 Timer type (OFF)
When p2 is set to ABSOLUTE (absolute time)
Syntax TQ p1,p2,p3,p4<terminator>
p1 Timer number
p2 Timer type (ABSOLUTE)
p3 Time interval (1MIN to 6MIN, 10MIN, 12MIN,
15MIN, 20MIN, 30MIN, 1H to 4H, 6H, 8H,
12H, 24H)
p4 Reference time (hh; fixed format)
hh Hour (00 to 23)
When p2 is set to RELATIVE (relative time)
Syntax TQ p1,p2,p3,p4<terminator>
p1 Timer number
p2 Timer type (RELATIVE)
p3 Time (hh:mm; fixed format)
hh Hour (00 to 24)
mm Minute (00 to 59)
p4 Reset at computation start (OFF, ON)
Query TQ[p1]?
Example Set the timeout value of timer number 1 to 10 hours
30 minutes. Set the timer so that it is not reset when
computation is started.
TQ1,RELATIVE,10:30,OFF
Description • Set p1 by referring to the table in section 3.3.
• You cannot use this command to configure
settings while recording (memory sampling) is
in progress.
• When p2 is set to RELATIVE, you can set p3
to a value less than or equal to 24:00.
TK Sets a match time timer
When p2 is set to OFF (the match time timer is
disabled)
Syntax TK p1,p2<terminator>
p1 Timer number
p2 Timer type (OFF)
When p2 is set to DAY (specify the time)
Syntax TK p1,p2,p3,p4,p5<terminator>
p1 Timer number
p2 Timer type (DAY)
p3 Day (1 to 28)
p4 Time (hh:mm; fixed format; 00:00 to 23:59)
p5 Timer operation (SINGLE, REPEAT)
SINGLE The action is executed once when
the condition is met.
REPEAT The action is executed each time
that the condition is met.
When p2 is set to WEEK (specify the day and time)
Syntax TK p1,p2,p3,p4,p5<terminator>
p1 Timer number
p2 Timer type (WEEK)
p3 Day of the week (SUN, MON, TUE, WED,
THU, FRI, SAT)
p4 Time (hh:mm; fixed format; 00:00 to 23:59)
p5 Timer operation (SINGLE, REPEAT)
When p2 is set to MONTH (specify the date and
time)
Syntax TK p1,p2,p3,p4,p5<terminator>
p1 Timer number
p2 Timer type (MONTH)
p3 Day (1 to 28)
p4 Time (hh:mm; fixed format; 00:00 to 23:59)
p5 Timer operation (SINGLE, REPEAT)