Yokogawa Value Series FX1000 - Manual (Page 114)

3-32
IM 04L21B01-17EN
Example Switch the FX to basic setting mode.
DS1
Description • You cannot set p1 to 1 when the FX is
recording (memory sampling) or computing, is
formatting an external storage medium, or is
storing data to an external storage medium.
• You cannot set p1 to 1 when the FX is
formatting an external storage medium or is
storing data to an external storage medium.
• To apply settings that you have changed using
the basic setting commands, you need to save
the settings using the XE command. Be sure
to save the settings using the XE command
before you change the execution mode
from the basic setting mode to the operation
mode. Otherwise, the new settings will not be
applied.
LO Loads setup data for setting
mode
Syntax LO p1,p2<terminator>
p1 File name (up to 32 characters)
p2 Medium
0 CF slot
1 USB
Example Load the setting mode setup data from a setup
file named SETFILE1.
LOSETFILE1
Description • When you specify the file name, do not specify
the extension.
• You can set p2 to 1 on models that have the
USB interface (/USB1 option).
• If you omit parameter p2, the medium is set to
the CF slot.
• You cannot use this command to load basic
setting mode setup data. To load setting mode
setup data and basic setting mode setup data,
use the YO command.
• You cannot use this command when there is
no external storage medium inserted in the
FX.
• You cannot use this command on models that
do not have a CF card slot or USB interface
(/USB1 option).
LI Saves setup data
Syntax LI p1<terminator>
p1 File name (up to 32 characters)
p2 Medium
0 CF slot
1 USB
Example Save setting mode setup data and basic setting
mode setup data to a file named SETFILE2 on
the CF card.
LISETFILE2
Description • When you specify the file name, do not specify
the extension.
• You can set p2 to 1 on models that have the
USB interface (/USB1 option).
• If you omit parameter p2, the medium is set to
the CF slot.
• An extension is appended to the file name
when you save the file.
• You cannot use this command when there is
no external storage medium inserted in the
FX.
• You cannot use this command on models that
do not have a CF card slot or USB interface
(/USB1 option).
CM Sets communication input data
(/M1, /PM1, and /PWR1 options)
Syntax CM p1,p2<terminator>
p1 Communication input data number
p2 Communication input data
The ranges are –9.9999E+29 to
–1.0000E–30 and 1.0000E–30 to
9.9999E+29. You can also specify 0.
Five significant digits
Query CM?
Example Set communication input data C01 to
1.0000E–10.
CMC01,1.0000E-10
EM Starts or stops the e-mail
transmission function (/C7
option)
Syntax EM p1<terminator>
p1 Action type
0 Start
1 Stop
Example Start the e-mail transmission function.
EM0
Description To use the e-mail transmission function, you
must configure the Ethernet interface, set e-mail
addresses, and enter the contents you want to
transmit.
3.5 Control Commands