Yokogawa Value Series FX1000 - Manual (Page 105)

3-23
IM 04L21B01-17EN
Commands
1
2
3
4
5
6
App
Index
TU Sets an event action
Syntax TU p1,p2,p3,p4,p5,p6,p7<terminator>
p1 Logic number (1 to 40)
p2 Event type
NONE
REMOTE
Remote control input
RELAY Alarm output relay
SWITCH Internal switch
ALARM Alarm
TIMER Timer
MATCHTIMETIMER Match time
USERKEY
USER key
p3 Event details
p2 = REMOTE Remote number
p2 = RELAY Relay number
p2 = SWITCH Internal switch number
p2 = TIMER Timer number
p2 = MATCHTIMETIMER
Match time timer
number
p2 = Any other value
Don’t care
p4 Action type
MEMORYSTART/STOP
Memory start or
memory stop
MEMORYSTART Memory start
MEMORYSTOP Memory stop
TRIGGER Event trigger
ALARMACK Alarm
acknowledgement
MATHSTART/STOP Starts or stops computation
MATHSTART
Starts computation
MATHSTOP Stops computation
MATHRESET Resets computation
SAVEDISPLAY Causes a timeout in
display data
SAVEEVENT Causes a timeout in
event data
MESSAGE Writes a message
SNAPSHOT Takes a snapshot
MANUALSAMPLE Performs manual
sampling
TIMERRESET Resets the relative
timer
DISPLAYRATE1/2 Switches the trend
interval
DISPLAYGROUPCHANGE Switches the display group
FLAG
Raises a flag
TIMEADJUST Adjusts the time
PANELLOAD Loads settings
p5 Action details 1
p4 = TIMERRESET Timer number
p4 = DISPLAYGROUPCHANGE
Display group number
p4 = FLAG Flag number
p4 = MESSAGE Message number (1 to
100)
p4 = PANELLOAD Setup file number (1 to
3)
p6 Action details 2
p4 = MESSAGE Method of specifying
the destination to write
the message
ALL All display groups
SELECT A specific display group
p7 Action details 3
p4 = MESSAGE and p6 = SELECT
Display group number
Query TU[p1]?
Example Use the remote control input (terminal 1) to execute
a memory start.
TUREMOTE,1,MEMORYSTART
Description • Set the numbers (such as the relay number
and internal switch number) by referring to the
table in section 3.3.
• Depending on the value of parameter p2 (event
type), there are some values that you cannot
select for parameter p4 (action type).
• Depending on other FX settings or the
installed options, there are some values that
you cannot select for parameter p4 (action
type).
• You can specify SNAPSHOT and
MANUALSAMPLE regardless of the FX
specifications. However, depending on
the FX specifications and the settings, the
corresponding functions may not operate.
• You cannot specify PANELLOAD on models
that do not have a CF card slot.
3.4 Setting Commands