Yokogawa Value Series FX1000 - Manual (Page 115)

3-33
IM 04L21B01-17EN
Commands
1
2
3
4
5
6
App
Index
CU Recovers Modbus manually
Syntax CU p1<terminator>
p1 Communication type
0 Modbus client (Ethernet)
1 Modbus master (serial)
YO Loads a setup file that includes
the settings for basic setting
mode
Syntax YO p1,p2<terminator>
p1 Name of the file to load (up to 32 characters)
p2 Medium
0 CF slot
1 USB
Example Load the CONFIG1 file from the CF card.
YOCONFIG1,0
Description • When you specify the file name, do not specify
the extension.
• You can set p2 to 1 on models that have the
USB interface (/USB1 option).
• If you omit parameter p2, the medium is set to
the CF slot.
• You cannot use this command on models that
do not have a CF card slot or USB interface
(/USB1 option).
YC Clears measured and computed
data and initializes setup data
Syntax YC p1<terminator>
p1 The types of data to be initialized and
cleared
0
Basic setting mode settings,
setting mode settings, measured
and computed data, and log data
(“Clear 1” on the FX)
1 Setting mode settings, measured
and computed data, and log data
(“Clear 2” on the FX)
2 Measured and computed data and
log data
(“Clear 3” on the FX)
Example Perform “Clear 3” on the FX.
YC2
IR Resets a relative timer
Syntax IR p1<terminator>
p1 Number of the timer to reset
0 All timers
1, 2, . . . Timer number
Example Reset timer 2.
IR2
Description Set p1 by referring to the table in section 3.3.
BV Enters a string (can only be used
during serial communication)
Syntax BV p1,p2<terminator>
p1 0
p2 Character string (up to 100 characters)
Example Enter “user123.”
BV0,user123
Description You can use this command to enter character
strings when the FX is displaying the character
input window.
KE Performs key operations
Syntax KE p1<terminator>
p1 Key
F1 to F5 Soft keys 1 to 5
ESC
ESC key
MENU MENU key
FUNC FUNC key
START START key
STOP
STOP key
USER USER key
DISP DISP/ENTER key
UP The up arrow key
DOWN The down arrow key
RIGHT The right arrow key
LEFT
The left arrow key
Example Press the DISP/ENTER key.
KEDISP
Description • This command performs the same operations
as pressing the keys on the FX. When you
send multiple key operations, send them in
the same order that you would perform them
on the FX.
• When you perform this command, it is logged
on the FX as “KEY.” This command is valid
regardless of whether the keys are locked.
3.5 Control Commands