HID FARGO HDPii User Guide - Manual (Page 104)

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
104
Telnet Command Line Interface
Initiating a Telnet Session
This procedure shows how to initiate a Telnet session from a PC in order to access the
Telnet services provided by the Printer.
Description
Initiating a
Telnet
session Follow these instructions to issue Telnet commands.
1. Identify the IP address of your Printer. (Note: See Switching to the
Automatic IP Address Mode Switching to the Automatic IP Address
Mode .)
2. Initiate a Telnet session from a DOS window on your PC. At the DOS
prompt, enter telnet [IP Address]
• Example: C:\>telnet 192.168.11.12
• All Telnet responses from the Printer will then be displayed in the
Telnet session on the PC.
• All commands entered will be sent to the Telnet client in the
Printer.
3. Enter “help” or “?” to get an on-window list of supported Telnet
commands.
Reviewing the Telnet Command Table
The following table describes available Telnet commands. (Note: You can enter partial full-
word commands: the Printer will respond with additional help. For example, you can enter
“list”, and the Printer will respond with all subcommands to the list command.)
Telnet Command Command Purpose Command Format
? Display help for Telnet ?