HID FARGO HDPii User Guide User Manual
Page 69
HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
69
Caution:
This device is electrostatically sensitive
. It may be damaged if
exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is
indicated by a warning symbol (as shown to the left).
• To prevent equipment or media damage, refer to the
following safety messages before performing an operation
preceded by this symbol.
• To prevent equipment or media damage, observe all
established Electrostatic Discharge (ESD) procedures while
handling cables in or near the Circuit Board and Printhead
Assemblies.
• To prevent equipment or media damage, always wear an
appropriate personal grounding device (e.g., a high quality wrist
strap grounded to avoid potential damage).
• To prevent equipment or media damage, always remove the
Ribbon and Cards from the Printer before making any repairs,
unless otherwise specified.
• To prevent equipment or media damage, take jewelry off of
fingers and hands, as well as thoroughly clean hands to remove
oil and debris before working on the Printer.
Troubleshooting - LCD and Printer Error Message
Tables
This section provides two troubleshooting tables for the LCD error messages and the Printer
error messages. Each table uses a 3-column presentation to present a specific LCD or
Printer error message, its cause and its solution.
• This allows the troubleshooter to identify the error and its cause, and then perform the
procedure (provided in the solution column).
• This standard mode of identifying the problem and its solution should provide an efficient
method of troubleshooting this Printer.
• If you encounter problems beyond the capabilities of these two error message tables, you
should contact