HID FARGO HDPii User Guide - Manual (Page 74)

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
74
No. 158)
Film Low
(PC Error Message
No. 156)
The HDP film will soon run
out. If printing a large number of
cards, replace the Film now or
monitor the Printer until the
Film is gone and install a new
Film.
Film Out
(PC Error Message
Nos. 156 and 157)
The HDP film has run out. Install a new roll of film and
press Resume to continue or
Cancel
to reset.
Film: Wrong Material
(PC Error Message
No. 173)
The HDP Film is not installed
properly or has been
damaged. Verify the correct film is
installed in the film Cartridge.
Flipper Jam
(PC Error Message
Nos. 74 and 199)
A card is jammed in the card
flipping area of the Printer. Open the Printer's Flipping
Module Cover.
Clear any cards in the Flipping
Module by opening the
Printers Cover and using the
Forward
and/or Back buttons
located on the Printer’s Front
Cover.
Ensure that the Output Module
can rotate freely. Close the
Printer's Flipping Module
Cover.
Press the Resume button on
the Printer’s Front Cover to
continue printing.
To cancel the print, press the
Cancel Print
button from the
Driver's display dialog.
Head Loading
(PC Error Message
No. 111)
An unrecoverable error has
occurred during printing. Reset the Printer and try
again. If this problem persists,
call for technical assistance.
Head Resistance
(PC Error Message
No. 6)
The EE setting in Driver for
head resistance is out of
range. Enter a value for head
resistance in the EE settings in
the Driver.
Reset the correct value
according to the steps in the
Troubleshooting Section.
If this problem persists, call for