HID FARGO HDPii User Guide User Manual

Page 76

Advertising
background image

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4

76

Mag Encoder Startup
Error

(PC Error Message
No. 63 and 141)

A problem was detected
during Printer start-up.

Reset the Printer and try
again.

If this problem persists, call for
technical assistance.

Mag Verify Error

(PC Error Message
No. 30)

Print could not verify MAG
write.
OR

The magnetic stripe was not
encoded properly.

Check the Cards and click on
Cancel Print.

Multiple Feed

(PC Error Message
No. 70)

Multiple cards were fed into
the Printer.

Remove all cards and try
again.

No E-card Encoder

(PC Error Message
No. 202)

You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type.

You are trying to send
encoding data, but the Printer
is not configured with this
Encoder type.

No Film

(PC Error Message
No. 28)

Film is not installed in
Printer.
OR

Film RFID tag is bad.

Install the Film and press
Resume

.

To cancel the print, press the
Cancel Print

button or the

Cancel

button located on the

Printer.

No Flip Module

(PC Error Message
No. 201)

Two-sided job sent to a one-
sided Printer.

Verify the Printer has flipper
capabilities via the LCD Menu.

If Output capabilities are
present, ensure that the Print
Both Sides

option in the

Driver is set correctly.

Press the Resume button on
the Printer’s Front Cover to
continue printing.

To cancel the print, press the
Cancel Print

button from the

Driver’s display dialog.

No iClass Encoder

(PC Error Message
No. 177)

You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type.

You are trying to send
encoding data, but the Printer
is not configured with this
Encoder type.

Advertising