HID FARGO HDPii User Guide - Manual (Page 288)

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
288
Replacing or cleaning the FAN foam filter.
Step Process
1 Grasp the top of the Inlet Fan Cover and pull OUT then UP to release
the tabs holding the bottom of the Inlet Fan Cover.
2 Remove the Foam Fan Filter Insert to replace or clean.
Clean with water and be sure the foam is dry before replacing into printer.
3 Replace the Inlet Fan Cover by fitting the bottom tabs in first then clicking the
top in place.
4 You have completed this procedure.