Using the transfer tof adjustment option – HID FARGO HDPii User Guide User Manual

Page 269

Advertising
background image

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4

269

Using the Transfer TOF Adjustment Option

Follow this instruction.

Step Procedure

1

Set the Transfer TOF to –40.

2

Print the alignment card self-test. (Note: The front edge should look like
Figure 280.1.)

3

Determine which TOF grid line is closest to the edge of the card.

4

Align the leading edge of the print to the leading edge of the card. Follow this
instruction:
• Adjust the Transfer TOF setting up or down by the number (located directly

to the right of the line found in the previous step).

• Determing this setting by using the (+/-) orientation arrows located at the

upper and lower left sections of the card.

5

Print the alignment card self-test. (Note: The leading edge should look like
Figure 280.2.)

6

Follow this instruction:

a. If the card is not aligned properly, make any additional changes necessary

using the Print TOF setting.

b. Print another alignment card.

c. Repeat the process as needed.

Advertising