HID FARGO HDPii User Guide User Manual
Page 108
![background image](/manuals/433176/108/background.png)
HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
108
Telnet Command
Command Purpose
Command Format
settings.
ifc
mode
Specify the Ethernet
interface mode as:
automatic, full or half duplex;
10 or 100 mHz. (NOTE: 100
mHz. is not supported by the
HDPii).
store ifc mode
auto|10half|10full|100half|1
00full
from
Set the Ethernet mode
settings from the default or
current settings.
store ifc from
default|current
Telnet Command
Command Purpose
Command Format
save
Save all current settings as
the stored settings in the
permanent memory.
save
load
Take the settings from the
stored memory and make
them the current settings.
load
lpstat Display
information
about
the Printer status.
This includes the status and
device response.
See the Printer web page
description.
lpstat
cancel
Cancel a specific print job
from the print queue.
cancel 10
quit
Stop the current Telnet
session.
quit