HID FARGO HDPii User Guide - Manual (Page 73)

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
73
No. 46)
E-Card Encoder
Startup Error
(PC Error Message
No. 141)
A problem was detected
during Printer start-up. Reset the Printer and try
again. If this problem persists,
call for technical assistance.
E-Card Startup Error
(PC Error Message
No. 141)
A problem was detected
during Printer start-up. Reset the Printer and try
again. If this problem persists,
call for technical assistance.
EEPROM Corrupt
(PC Error Message
Nos. 38, 39, 40, and
144)
EEPROM restored with
factory default values. If changes were, then go into
the setting values and reset
these numbers.
Ejecting Card
(PC Error Message
No. 72)
The card has been ejected
already. Click OK to clear the
message. The user might
want to know that a card has
been sent to the reject bin, or
out of the Printer, and is either
incomplete or posses a
security risk if not disposed of
properly.
Empty Reject Bin
(PC Error Message
No. 265)
The reject bin is full. Remove the large number of
rejected cards from the reject
bin.
Click OK to clear the
notification message. (Note:
In some cases, rejected cards
are incomplete or pose a
security risk, and should be
disposed of properly.)
Failed To Initialize
(PC Error Message
No. 141)
A problem was detected
during Printer start-up. Reset the Printer and try
again. If this problem persists,
call for technical assistance.
Film Align Error
(PC Error Message
Nos. 26 and 176)
The film is not able to move
correctly. Check for
jams/breaks. Check for obstruction. If the
problem persists, call for
technical assistance.
Film Break/Jam
(PC Error Message
The film is not able to move
correctly. Check for
jams/breaks. Check for obstruction. If the
problem persists, call for
technical assistance.