HID FARGO HDPii User Guide - Manual (Page 23)

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
23
(built-in bolt-holes or a Kensington-type lock receptacle).
Power Supply • 80W for HDPii
(Note: This product is intended to be supplied by a Listed Power
Unit marked "Class 2" and rated for 24 V dc, 3.75 to 5 A.)
Print Area Over-the-edge on CR-80 cards.
Printing Method HDP™ Dye-Sublimation / Resin Thermal Transfer
Print Ribbon
Options HDPii (prints or images):
• Full color, YMC*, 750 prints
• Full color with resin black, YMCK*, 500 prints
• Full color with two resin black Panels, YMCKK*, 500 prints
• Full color YMC with resin black and heat seal panel for difficult-
to-print surfaces, YMCKH*, 500 prints
• Full Color/Resin Black/Inhibit, YMCKI**, 500 prints
• Full Color/2 Resin Black/2 Inhibit, YMCKIKI**, 350 prints
Premium Resin, K
*Indicates the Ribbon type and the number of Ribbon panels printed
where Y=Yellow, M=Magenta, C=Cyan, K=Resin Black, H=Heat
Seal, and I=Inhibit
** The Inhibit or I designation under YMCKI and YMCKIKI
indicates the ability to prevent the transfer of film to the card
surface. Users can select these Ribbon types to prevent film
from transferring over security features, signature panel or
other areas of special interest on the card surface.
Print Speed-
Batch Mode Print Speed - Batch Mode:
• 26 seconds per card / 138 cards per hour (YMC with transfer)*
• 32 seconds per card / 113 cards per hour (YMCK with
transfer)*
• 47 seconds per card / 77 cards per hour (YMCKK with
transfer)*
• 43 seconds per card / 84 cards per hour (YMCKI single side
with transfer)*
• 52 seconds per card / 69 cards per hour (YMCKI single side
with transfer. (YMC Front Side / KI back side)*
• 64 seconds per card / 56 cards per hour (YMCKI single side
with transfer. (with Financial Mag Encoding)**
*Print speed indicates an approximate print speed. It is measured