HID FARGO HDPii User Guide - Manual (Page 77)

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
77
No Mag Module
(PC Error Message
No. 31)
MAG encoding job sent to
Printer without MAG
encoder.
You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type.
No MiFare Encoder
(PC Error Message
No. 203)
You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type. To cancel, click on Cancel
Print
.
No Prox Encoder
(PC Error Message
No. 32)
You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type. To cancel, click on Cancel
Print
.
No Ribbon
(PC Error Message
No. 25)
No Ribbon is installed in the
Printer.
OR
Ribbon RFID tag is bad.
Install the correct Ribbon and
press the Resume button
located on the Printer’s LCD
display.
To cancel the print, press the
Cancel Print
button from the
Driver's display dialog and the
Cancel
button located on the
Printer's LCD display.
No Smart Encoder
(PC Error Message
No. 33)
You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type. To cancel, click on Cancel
Print
.
Output Hopper Full The Sensor detects when
the Output Hopper has been
filled to prevent more cards
from printing and causing a
jam. Check the Hopper and remove
cards as needed. Close the
Output Hopper. Press the
Resume
button.
Output Hopper Open The Sensor detects when
the Output Hopper has been
opened. When the Hopper
is opened, cards will not
eject from the Output (to
ensure cards do not eject
into the chassis).
Close the Output Hopper.
Press the Resume button.
Reject Output
Hopper The Sensor detects that the
number of cards rejected is
getting close to the 30-card