HID FARGO HDPii User Guide - Manual (Page 75)

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
75
technical assistance.
Head Sensor Error
(PC Error Message
No. 8)
The Printhead Temperature
Sensor is not functioning or
is not connected properly.
OR
The Printhead is not cooling
properly.
If the problem persists, call for
technical assistance.
Head Voltage Error
(PC Error Message
Nos. 103 and 105)
A hardware fault has
prevented setting the correct
Printhead voltage. Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Headlift Error
(PC Error Message
Nos. 102, 103, 104,
and 105)
This is a problem with the
Printhead Lift or Transfer
Roller Headlift. Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Heater Error
(PC Error Message
No. 161)
The Transfer Heater Roller is
too hot. Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Invalid Film
(PC Error Message
Nos. 94, 95, 96, 164,
165, and 166)
An unauthorized film is
installed in the Printer. Get the correct Film from your
dealer.
Invalid Password
(PC Error Message
No. 136)
Printing disabled at this time. Press Cancel to abort this
print job and then check
security settings at host
computer.
Invalid Ribbon
(PC Error Message
No. 93)
An unauthorized Ribbon is
installed in the Printer. Get the correct Ribbon from
your dealer.
Job Data Error
(PC Error Message
No. 106)
The print data sent to the
Printer is corrupt or has been
interrupted. Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Mag Encoder Paused
(PC Error Message
No. 143)
The Magnetic Encoder is in
a pause state.