HID FARGO HDPii User Guide - Manual (Page 72)

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
72
No. 159)
Calibrate Ribbon
(PC Error Message
Nos. 128 and 170)
The print Ribbon Sensor is
out of calibration. Select Cancel and then
perform the Ribbon calibration
procedure.
Card Feed Stop
(PC Error Message
No. 137)
The Front Cover was
opened. This caused the
card transfer to stop OR the
pause button was selected. Press Resume or Cancel.
Card Jam
(PC Error Message
Nos. 82, 112, and
200)
A card is jammed in the Print
Station or card flipping area
of the Printer. Clear the jam.
Card Jam: Prox
(PC Error Message
No. 86)
A card is jammed in the
PROX card encoding area of
the Printer. Clear the jam.
Card Jam: Smart
(PC Error Message
No. 85)
A card is jammed in the
smart card encoding area of
the Printer. Clear the jam.
Card Jam: Trans
(PC Error Message
No. 83)
Card became jammed in
Printer during transfer. Clear the jam.
Card Not Found
(PC Error Message
No. 69)
Card cannot be found in the
Printer. Verify card not jammed in
Printer and select Cancel.
Check Film
(PC Error Message
No. 244)
The film is not able to move
correctly. Check for
jams/breaks. Check for obstruction. If the
problem persists, call for
technical assistance.
Clean Printer
(PC Error Message
No. 71)
For best Printer
performance, replace the
Cleaning Roller Tape
and clean the Printer’s Feed
Rollers and Printhead at this
time. See the appropriate Cleaning
procedures in this document.
Cover is Open
(PC Error Message
The Cover was left open. Ensure that the Cover is
properly closed.