HID FARGO HDPii User Guide - Manual (Page 117)

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
117
Changing to the Static IP Address Mode
Step Procedure
1 Select the Network link from any web page of the Printer.
2 Select the Use the following IP address radio button, which prepares the
Printer to use network settings (that the User has manually set).
These manual settings will then be used the next time the Printer is
rebooted.
3 Enter the network settings which are required for Ethernet communications
from within the same subnet.
With only these entries the User will be unable to print from a subnet other
than the subnet on which the Printer is connected. These required settings
are the following:
• IP Address
• Subnet Mask
4 Enter the optional network settings for Ethernet communications across a
router from other subnets, as follows:
• Default Gateway
5 Enter the optional network settings for DNS. These are the following:
• DNS Server Address
• DNS Domain Suffix
6 Select the Submit button to save these changes to stored settings in the
memory of the Printer. (Note: These settings will not be lost if the power is
removed from the Printer.)
7 Login as a root User if you are so prompted. (Note: Any change of setting
will only be accepted after you have successfully logged in.)
8 Reboot the Printer to effect this change.
See the Reviewing Web page security procedure (below).