HID FARGO HDPii User Guide - Manual (Page 79)

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
79
(PC Error Message
No. 91, 100 and 101) out. Resume to continue.
Ribbon Tension
(PC Error Message
No. 98)
The Ribbon tensions may be
out of range. Check and adjust the setting
through the TOOLBOX under
the Advanced Settings tab.
If this problem persists, call for
technical assistance. Press
Resume
to continue or cancel
to abort.
Ribbon: Wrong
Material
(PC Error Messages
No. 93, 122, and
172)
The print Ribbon is not
installed properly or has
been damaged. Verify the correct Ribbon is
installed in the Ribbon
Cartridge.
System Fault
(PC Error Message
No. 164)
Unspecified system error is
detected by the Printer
Firmware. Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Unable to Feed
(PC Error Message
Nos. 14 and 81)
The Printer is unable to feed
a card from the
C ard
Cartridge.
Verify there are cards in the
Card Cartridge.
Verify cards are not stuck
together or jammed, and they
are the correct thickness..
Utility Error
(PC Error Message
Nos. 129)
Command resulted in an
error. See Resolving the
Communications Errors .
Waiting for Data
(PC Error Message
No. 147)
The Printer has stopped
receiving data from the PC. Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Wrong Film
(PC Error Message
Nos. 162 and 163)
The print film installed in the
Printer does not match the
film type selected in the
Printer Driver.
OR
A Self-test job cannot be
printed with the print media Replace film in Printer with
type specified in the Driver.
A reboot is required.