BNC 1105 Universal Counter - Manual (Page 113)

113 113 113 113
generated.
If the current measurement function is Totalize or Voltage Peaks, a “0” will be
returned and error -221 will be generated.
:CALCulate2:LIMit:PCOunt[:TOTal]?
Queries the total number of measurements that pass the limit test.
Return
Numeric data transferred as ASCII bytes in <NR1> format.
Notes
If the limit test is off, a “0” will be returned and error -221 will be generated.
If there is no valid measurement result, a “0” will be returned and error -230 will be
generated.
If the current measurement function is Totalize or Voltage Peaks, a “0” will be
returned and error -221 will be generated.
:CALCulate2:LIMit:STATe <Boolean>
Defines or queries the limit test state.
Return
A single ASCII-encoded byte is returned. 0 means OFF and 1 means ON.
Notes
This will be set to OFF after the counter has been turned off or a remote interface
reset.
The limit data and the :CALC2:LIM:FAIL, :CALC2:LIM:FCO and :CALC2:LIM:PCO
information will be cleared.
Sets the limit-detect output to the in-limit voltage level.
:CALCulate2:LIMit:LOWer[:DATA] <numeric value> [HZ|S|DEG]
Sets or queries the lower limit in the limit test.
Return
Numeric value transferred as ASCII bytes in <NR3> format with eleven significant
digits.