BNC 1105 Universal Counter - Manual (Page 37)

37 37 37 37
cancel the changes, press the softkey under CANCEL.
4.2.2 Measurement Control Keys (Run and
Stop/Single)
There are two measurement modes in the MODEL 1105: Run and Single
modes. Users can press the Run key to put the Counter in the Run mode
while the Stop/Single key is in the Single mode.
Run mode operations
If the MODEL 1105 is under one of the measurement modes, press
the Run key to make the MODEL 1105 enter the Run mode and start
continuous measurements.
If the MODEL 1105 is under one of the measurement modes, press
the Run key again to make the Counter abort the on-going
measurement and (re-)enter the Run mode. This also clears any
statistics being collected.
If the MODEL 1105 is under one of the measurement modes, press
the Stop/Single key to make the Counter stop the measurement.
If the MODEL 1105 is under the Run mode, select another
measurement function to make the Counter abort the on-going
measurement.
Single mode operations
If the MODEL 1105 is under one of the measurement modes, and
on-going measurement is actuated, press the Stop/Single key to
make the Counter enter the single mode and make single
measurement or N measurements if STATS:SINGLE:N is selected
and STATS:N CNT is set to N (refer to Ch.4.6). After the
measurement is done, the Counter automatically exits the Single
mode.
If the MODEL 1105 is under the Run mode, press the Stop/Single
key to make the MODEL 1105 enter the Single mode.
If the MODEL 1105 is under the Single mode, press the Stop/Single
key to cause the Counter to abort the current measurement.