BNC 1105 Universal Counter - Manual (Page 73)

73 73 73 73
[:VOLTage]:PWIDth [<reference>][,(@1)]
[:VOLTage]:NWIDth [<reference>][,(@1)]
[:VOLTage]:INITerval [(@1),(@2)]
[:VOLTage]:PTPeak [(@1),(@2)]
[:VOLTage]:MAXimum [(@1),(@2)]
[:VOLTage]:MINimum [(@1),(@2)]
[:VOLTage]:CENTer [(@1),(@2)]
[:VOLTage]:PHASe [(@1),(@2)]
[:VOLTage]:DCYCle [<reference>][,(@1)]
[:VOLTage]:PDUTycycle [<reference>][,(@1)]
[:VOLTage]:TOTalize:CONTinuous [(@1)]
[:VOLTage]:TOTalize:TIMed [<gate_time>][,(@1)]
The READ? Command
The command READ? is often used with the command CONFigure? to
have a effect similar to the command MEASure? in which the users
provide required parameters, configure the counter and make
measurements. The command :CONFigure? does the configuration part
of the measurement, and the command :READ? does the data
acquisition and post processing (if any), and puts the result in the Output
queue. Use this command combination to instruct the counter to perform
something between the measurement setup and data acquisition.
:READ[[:SCALar]:<function>]?
For more information about <function>, <parameters> and <source_list>, please
refer to the above table.
Using the command READ? has a same effect as using the command
INITiate[:IMMediate] followed by the command :FETCh?.
:READ
:READ[:SCALar]
[:VOLTage]:FREQuency?
[:VOLTage]:FREQuency:RATio?
[:VOLTage]:PERiod?
[:VOLTage]:RISE:TIME?
[:VOLTage]:RTIMe?
[:VOLTage]:FALL:TIME?