BNC 1105 Universal Counter - Manual (Page 48)

48 48 48 48
softkey under Cancel to withdraw the changes.
Remote interface command
Use the following command to specify the value of Offset:
:TRACe[:DATA] OFFSET,<numeric value> [HZ|S|DEG]
To specify Set Offs?
To enable Set Offs, the value will be set in negative automatically.
1. Press Scale & Offset button.
2. Press the softkey under Set Offs?
4.5 Limits Operations
The MODEL 1105 lets you set upper and lower measurement limits, and
you can instruct the Counter to stop or keep measuring when the
measurement exceeds the limits.
Please note that the Limit Modes are not available for the Totalize
(located in Other Meas.) and the Voltage Peak measurement.
By the functions on the Limit Modes as shown in the Figure 4-11, users
can stop measurement as they set (OnFail: Stop), and get measured
value exceeding user-defined parameters. On the contrary, the
measurement can keep going as the setting is (OnFail: Go on), although
measurement exceeds user-defined parameters. And the exceeded
values will be transmitted to another unit for diagnosing via USB as the
(OUT* USB) is enabled.
Figure 4-11
Besides, the (OnFail: Stop) won’t effect any change under single
measurement mode.