BNC 1105 Universal Counter - Manual (Page 60)

60 60 60 60
time-out limit, the counter will send a not-a-number value to the
computer. For this purpose, the counter can prevent keeping
measurement. Besides, the time out “OFF” is set to disabled the function.
Figure 4-29
1. Press the UTILITY button.
2. Use the softkey under Syst to enter the system setup menu.
3. To enable/disable beeper: press the softkey under BEEP to toggle
between OFF and ON.
4. To run self-test: press the softkey under SelfTest to start the test.
(While doing self-test, all connected source leads on the Model 1105
must be released. The followings are the error codes for your
reference.)
0x0002:CHANNEL 1 Front End FAIL
0x0004:CHANNEL 1 Front End FAIL
0x0008:CHANNEL 2 Front End FAIL
0x0010:CHANNEL 2 Front End FAIL
0x0020:CHANNEL 1 AD FAIL
0x0040:CHANNEL 1 AD FAIL
0x0080:CHANNEL 2 AD FAIL
0x0100:CHANNEL 2 AD FAIL
0x0400:FPGA 1 FAIL
5. To select dot convention: press the softkey under Dot 9.0 to toggle
between dot and comma conventions.
6. To enable/disable time out: press the softkey under TOUT to toggle
between OFF and ON.
Remote Interface Command
*TST?
:SYSTem:BEEPer:STATe ON|OFF
:DISPlay[:WINDow]:TEXT:RADix DPOint︱COMMa
:SYSTem:TOUT ON|OFF
: SYSTem:TOUT:TIMe <numeric_value>