Weidmuller ACT20X - Manual (Page 52)

Product Installation / Operation, ACT20X-HUI-SAO (Universal Converter)
52 1066540000/01/12.11
Calibration temperature +20…28 °C
General Specifications
Communications interface,
adapter / configuration software / FDT-DTM
device driver CBX200 USB / "WI-Manager" / ACT20X DTM
Dimensions (H x W x D) 105.6 x 22.5 x 114.7 mm
Protection degree IP20
Screw terminal torque 0.5 Nm
Vibration IEC 60068-2-6, test Fc, 1g, 2…100 Hz
Vibration, continuous IEC 60068-2-64, test Fh, 1g, 3…100 Hz
Wire size, stranded wire AWG 26…14 / 0.13…2.08 mm²
EMC immunity influence ≤ 0.5 % of span
Extended EMC immunity:
NAMUR NE 21, A criterion, burst ≤ 1 % of span
Signal/Noise ratio min. 60 dB (0…100 kHz)
Response time (0…90 %, 100…10 %):
Temperature input, programmable
mA / V input, programmable
1…60 s
0.4…60 s
Default Settings
Input type Temperature
Connection type 3-wire
Temperature unit °C
Temperature sensor type Pt100
Temperature range 0…150 °C
Output current range 0…20 mA
Output current on error 23 mA
Analog output response time (1/10 s) 1 s
Relay Software Parameters / Default Settings
Function SETPOINT
Contact function Normally Open (NO)
Setpoint 50 °C (input type temperature) / 50 %
Activation direction Increasing
Hysteresis 1 °C (input type temperature) / 1 %