Rockwell Automation 22-COMM-E EtherNet/IP Adapter - Manual (Page 17)

Getting Started 1-5
This section is provided to help experienced users quickly start using the
EtherNet/IP adapter. If you are unsure how to complete a step, refer to
the referenced chapter.
Quick Start
Step Refer to . . .
1 Review the safety precautions for the adapter. Throughout This
Manual
2 Verify that the PowerFlex drive is properly installed. Drive User Manual
3 Install the adapter.
Verify that the PowerFlex drive is not powered. Then, connect
the adapter to the network using an Ethernet cable and to the
drive using the Internal Interface cable. Use the captive screw
to secure and ground the adapter to the drive. Chapter 2 ,
Installing the
Adapter
4 Apply power to the adapter.
The adapter receives power from the drive. Apply power to
the drive. The status indicators should be green. If they flash
red, there is a problem. Refer to
Chapter 8 , Troubleshooting .
Chapter 2 ,
Installing the
Adapter
5 Configure the adapter for your application.
Set the following parameters for the adapter as required by
your application:
• IP address, subnet mask, and gateway address
• Data rate
• I/O configuration
• Fault actions
Chapter 3 ,
Configuring the
Adapter
6 Create a ladder logic program.
Use a programming tool such as RSLogix to create a ladder
logic program that enables you to:
• Control the adapter and connected drive using I/O.
• Monitor or configure the drive using Explicit Messages.
Chapter 4 ,
Configuring the
Scanner or Bridge
Chapter 5 ,
Using I/O Messaging
Chapter 6 ,
Using Explicit
Messaging