Rockwell Automation 22-COMM-E EtherNet/IP Adapter - Manual (Page 34)

3-10 Configuring the Adapter
By accessing the IP address set for the adapter using a web browser, you
can view the adapter’s web pages for information about the adapter, the
PowerFlex drive to which it is connected, and other DSI devices
connected to the drive such as HIMs, serial adapters or other daisy-
chained drives (when adapter is in Multi-Drive mode). Additionally, the
adapter can be configured to automatically send e-mail messages to
desired addresses when selected drive faults occur and/or are cleared,
and/or when the adapter takes a communication or idle fault action. For
more details on the adapter’s web pages, refer to
Chapter 9 , Viewing the
Adapter’s Web Pages .
By default, the adapter web pages are disabled.
To enable the adapter web pages
• Refer to
Figure 2.1 and set the Web Pages Switch (SW2) to the
“Enable Web” (up) position.
Important: For a change to the switch setting to take effect, the
adapter must be reset (see Resetting the Adapter section
in this chapter).
Bit 0 of Parameter 30 - [Web Features] is used to protect the
configured settings for e-mail notification. By default, settings are not
protected. To protect an e-mail configuration, set the value of E-mail Cfg
Bit 0 to “0” (Disabled). You can unprotect the configuration by changing
Bit 0 back to “1” (Enabled). E-mail notification will always remain
active regardless of whether or not its settings are protected — unless
e-mail notification was never configured. For more information about
configuring adapter e-mail notification or stopping e-mail messages,
refer to
Chapter 9 , Configure E-mail Notification Web Page .
Figure 3.11 Web Features Screen on Powerflex 4-Class HIM (22-HIM-*)
Bit 0 is the right-most bit. In Figure 3.11 it is highlighted and equals “1.”
Changes to this parameter take effect immediately. A reset is not
required.
Setting Web Features Access
Bit Description
0 E-mail Cfg (Default = 1 = Enabled)
1 Proc Dsp Cfg (Default = 1 = Enabled)
2 - 7 Not Used
Access Control
Parameter: # 030
x x x x x x 1 1
VALUE LIMITS SEL X