Rockwell Automation 22-COMM-E EtherNet/IP Adapter - Manual (Page 37)

Chapter
4
Configuring the Scanner or Bridge
Chapter 4 provides instructions on how to configure a ControlLogix
bridge to communicate with the adapter and connected PowerFlex drive.
After the adapter is configured, the connected drive and adapter will be a
single node on the network. This chapter provides the steps that are
needed to configure a simple network like the network in
Figure 4.1 . In
our example, we will configure a 1756-ENBT bridge to communicate
with a drive using Logic Command/Status and Reference/Feedback over
the network.
Figure 4.1 Example EtherNet/IP Network
Topic Page Topic Page
Example Network 4-1 Adding the Adapter and Drive to the
I/O Configuration 4-4
Adding a Bridge or Scanner to the
I/O Configuration 4-2 Saving the Configuration 4-7
Example Network
PWR
STS
PORT MOD NET A NET B
IP Address 131.200.130.176
ControlLogix Controller with
1756-ENBT Bridge
Computer with
Ethernet Connection
IP Address 131.200.130.178
PowerFlex 40 Drive with
EtherNet/IP Adapter
Switch