Rockwell Automation 22-COMM-E EtherNet/IP Adapter - Manual (Page 19)

Chapter
2
Installing the Adapter
Chapter 2 provides instructions for installing the adapter in a
PowerFlex 40 drive.
Before installing the EtherNet/IP adapter:
• Read the EtherNet/IP Performance and Application Guide,
Publication ENET-AP001
…, and the EtherNet/IP Media Planning and
Installation Manual, Publication ENET-IN001
….
• Verify that you have all required equipment. Refer to
Chapter 1 ,
Getting Started .
Important: To guard against device malfunction, use a grounding wrist
strap when installing the EtherNet/IP adapter.
Before installing the adapter, you must set its Operating Mode Switch
for Single or Multi-Drive operation. To use the adapter web pages, the
Web Pages Switch must be set to its “Enable Web” position.
Important: New settings are recognized only when power is applied to
the adapter, or the adapter is reset. If you change a setting,
cycle power or reset the adapter.
Topic Page
Preparing for an Installation 2-1
Setting Operating Mode and Web Pages Switches 2-1
Connecting the Adapter to the Network 2-3
Connecting the Adapter to the Drive 2-4
Applying Power 2-6
Commissioning the Adapter 2-6
Preparing for an Installation
Setting Operating Mode and Web Pages Switches