Rockwell Automation 22-COMM-E EtherNet/IP Adapter - Manual (Page 24)

2-6 Installing the Adapter
1. Install the required special cover on the drive. The status indicators
can be viewed on the front of the drive after power has been applied.
2. Apply power to the PowerFlex drive. The adapter receives its power
from the connected drive. When you apply power to the product for
the first time, the status indicators should be green or off after an
initialization. If the status indicators go red, there is a problem. Refer
to
Chapter 8 , Troubleshooting .
To commission the adapter, you must set a unique IP address. (Refer to
the
Glossary for details about IP addresses.) After installing the adapter
and applying power, you can set the IP address by using a BOOTP server
or by setting parameters.
By default, the adapter is configured so that you must set the IP address
using a BOOTP server. To set the IP address using parameters, you must
disable the BOOTP feature. Refer to
Chapter 3 , Configuring the
Adapter , for details.
Important: New settings for some parameters (for example,
Parameters 03 - [IP Addr Cfg 1] through 06 - [IP Addr
Cfg 4]) are recognized only when power is applied to the
adapter or it is reset. After you change parameter settings,
cycle power or reset the adapter.
Applying Power
!
ATTENTION: Risk of equipment damage, injury, or death exists.
Unpredictable operation may occur if you fail to verify that parameter
settings and switch settings are compatible with your application.
Verify that settings are compatible with your application before
applying power to the drive.
Commissioning the Adapter