Rockwell Automation 22-COMM-E EtherNet/IP Adapter - Manual (Page 36)

3-12 Configuring the Adapter
The following parameters provide information about how the adapter is
configured. You can view these parameters at any time.

Viewing the Adapter Configuration
Number Name Description
01 Mode The mode in which the adapter is set:
Values
0 = Single drive operation
2 = Multi-Drive operation
16 EN Rate Act The data rate used by the adapter:
Values
1 = 10M bits/sec full
2 = 10M bits/sec half
3 = 100M bits/sec full
4 = 100M bits/sec half
23 DSI I/O Act Indicates the Drives that are active in the Multi-Drive mode:
Bit Definitions
0 = Drive 0 Active
1 = Drive 1 Active
2 = Drive 2 Active
3 = Drive 3 Active
4 = Drive 4 Active
29 Web Enable Indicates the setting of the Web Pages Switch (SW2) on the
adapter when the adapter was last reset:
Values
0 = Disabled
1 = Enabled