Rockwell Automation 22-COMM-E EtherNet/IP Adapter - Manual (Page 22)

2-4 Installing the Adapter
1. Remove power from the drive.
2. Use static control precautions.
3. Mount the adapter on the required special drive cover (ordered
separately — see Figure 2.4 for part numbers).
• C Frame: Use the adapter screw to secure the adapter to the cover.
• B Frame: Disregard the screw and snap the adapter in place.
Important: For C Frame drives, tighten the adapter’s lower left screw to
ground the adapter (see Figure 2.4 ). For B Frame drives,
install the special drive cover onto the drive using both
cover fasteners to ground the adapter.
4. Connect the Internal Interface cable to the DSI port on the drive and
then to the mating DSI connector on the adapter.
Figure 2.3 DSI Ports and Internal Interface Cables
Connecting the Adapter to the Drive
Item Description
➊
DSI Connector
➋
15.24 cm (6 in.) Internal Interface cable
➌
Ethernet cable
PowerFlex 40 Drive
(C Frame shown
with cover removed) Back of Required Special Drive Cover
(ordered separately):
Part Number 22B-CCB for B Frame
Part Number 22B-CCC for C Frame
➋
EtherNet/IP Adapter
➊
➌