Rockwell Automation 22-COMM-E EtherNet/IP Adapter - Manual (Page 21)

Installing the Adapter 2-3
1. Remove power from the drive.
2. Use static control precautions.
3. Remove the drive cover.
4. Connect an Ethernet cable to the EtherNet/IP network. See Figure
2.2 for an example of wiring to an EtherNet/IP network.
Figure 2.2 Connecting the Ethernet Cable to the Network
5. Route the Ethernet cable through the bottom of the PowerFlex drive
( Figure 2.3 ), and insert the cable’s plug into the mating adapter
receptacle.
Connecting the Adapter to the Network
!
ATTENTION: Risk of injury or death exists. The PowerFlex drive
may contain high voltages that can cause injury or death. Remove
power from the PowerFlex drive, and then verify power has been
discharged before installing or removing an adapter.
Switch
ControlLogix with
EtherNet/IP Bridge
PowerFlex 40
with 22-COMM-E
Router
(optional)
EtherNet/IP
PowerFlex 40
with 22-COMM-E