Rockwell Automation 2706-MB1 MESSAGEVIEW 421 SOFTWARE MANUAL - Manual (Page 20)

2–3 Installing MessageBuilder Software
Publication 2706-817
9. You are prompted to begin the MessageBuilder installation. The
installation software checks your system for MessageBuilder
software.
If it detects a previous version of MessageBuilder software, it
warns you that the previous version will be deleted before the
new version is installed.
If it detects the same version of MessageBuilder software, it gives
you the option of re-installing or deleting the files.
– Re-install writes over existing files
– Delete removes the files; you must then run the installation
again to install the new software.
10. Enter registration information: name, company name, and
product serial number. The serial number is on your registration
card.
11. Enter target drive and directory for installing files. Recommended
drive and directory is C:\AB.
The files are copied to the target directory.
12. Insert MessageBuilder disk 2 to install the remaining files.
13. You are prompted to install the INTERCHANGE software. Enter
target drive and directory for installing files.
Recommended drive and directory is C:\RSI\IC.
The files are copied to the target directory.
•
If the installation detects a previous version of
INTERCHANGE, the procedure replaces existing components
with new components. The procedure will not overwrite
configuration files.
•
If the installation detects the same version of
INTERCHANGE, you are allowed to reinstall the
components.
14. Insert MessageBuilder Disk 3 to install the remaining
INTERCHANGE files.