Rockwell Automation 2706-MB1 MESSAGEVIEW 421 SOFTWARE MANUAL - Manual (Page 28)

2–11 Installing MessageBuilder Software
Publication 2706-817
Memory Manager Options
Load drivers high when enabled (checked) loads INTERCHANGE
drivers (executables) into high memory. Drivers are not loaded until
you reboot the computer. If this option is disabled, drivers are loaded
into the base 640K memory.
MessageBuilder recommends: Either enabled or disabled.
Memory Manager Selection allows you to specify the memory
manager in use on your system. Select one of the radio buttons.
MessageBuilder recommends: EMM386.
Driver Self-Test
When enabled this option requires KT devices to run self-diagnostics
before loading driver configuration.
MessageBuilder recommends: Perform the tests.
RNA Parameters
Use upper memory for packet buffers when enabled places packet
buffer space in upper MS-DOS memory.
MessageBuilder recommends: Use upper memory.
Number of solicited buffers allocates the number of packet buffers
(1 to 200). Each buffer uses 300 bytes of memory. The default is 20.
MessageBuilder recommends: 20 buffers.
Number of unsolicited data items allocates space for unsolicited
messages (0 to 200).
MessageBuilder recommends: 0 data items, which allocates no
space.
PCMK Enabler Selection
Specifies the Enabler to use for the 1784-PCMK on the DH+ Device
Driver.
Specific Enabler uses PCMKINIT or RSIPCMK. This Enabler
requires you to enter the socket number containing the card in the
driver dialog. The INTERCHANGE socket numbers are (0 to 7). In
Windows 95, the sockets are numbered (0 to 8).
Generic Enabler uses PCENABLE. This Enabler requires that you
enter a Memory address and IRQ (Interrupt).
MessageBuilder recommends: (Ignores).