Parts list – Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start User Manual
Page 11
Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012
11
Preface
Parts List
You need these parts to complete the tasks described in this quick start.
For a list of parts required to complete the prerequisite tasks listed in
Complete before Using This Quick Start on page 6
, see the documentation describing those
tasks.
Quantity
Cat. No.
Description
1
2097-V31PR2-LM
Kinetix 350 Single Axis Ethernet/IP Servo Drive
1
MPL-A310P-MJ72AA
MP-Series Low-inertia Servo Motor
1
The connectors required to
use Kinetix 350 drives vary
by drive catalog number.
The specific connectors to
be used with your
2097-V31PR2-LM drive
ship with the drive.
You do not need to order
this part separately.
6-pin Safe Torque Off (STO) Connector
1
6-pin Motor Power (MP) Connector
1
24V DC Back-up Power (BP) Connector
1
4- pin General-purpose AC Input Power (IPD) Connector
1
2097-TB1
Bulletin 2097 I/O Terminal Expansion Block - 50-pin SCSI I/O (IOD) Connector
1
2090-CPWM7DF-16AA03
6-pin Standard Power Cable with SpeedTec DIN Connector Type 923
1
2090-CFBM7DD-CEAA03
Standard Feedback Cable with SpeedTec DIN Connector Type 623
1
1585J-M8PBJM-2
RJ45 to RJ45 patchcord Ethernet cables
3
Jumper wires