Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start - Manual (Page 21)

Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012 21
Prepare the Kinetix 350 Drive Hardware Chapter 1
5. Connect a wire from a +24V DC terminal on the external power supply to pin 29
(ENABLE signal) on the IOD connector.
6. Insert the IOD connector into the
drive in the location shown in this
graphic.
IMPORTANT Do not connect power to the
external power supply.
Pin 26
Pin 25 Pin 46
Pin 47
Pin 48
Pin 49
Pin 50
Pin 29
Pin 28
Pin 27
+
-
User-supplied
24V DC Power
Supply
I/O Connection