Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start - Manual (Page 27)

Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012 27
Prepare the Kinetix 350 Drive Hardware Chapter 1
Connect the Kinetix 350 Drive to the EtherNet/IP Network
Complete these steps to connect the 2097-V31PR2-LM drive to the EtherNet/IP network.
1. Connect one end of the 1585J-
M8PBJM-2, RJ45 to RJ45
patchcord Ethernet cables to the
Ethernet connector on the front of
the Kinetix 350 drive.
2. Connect the other end of the
Ethernet cable to the EtherNet/IP
network.
Assign an IP Address to the Kinetix 350 Drive
You can assign an IP address to the 2097-V31PR2-LM drive manually via the drive keypad or
dynamically via a DHCP-enabled server. Because this publication describes tasks intended to be
completed on a private network, you assign an IP address via the drive keypad.
The graphic shows which buttons to
push on the keypad to make changes.
Before assigning the IP address
manually, disable the DHCP mode.
IMPORTANT If you do not disable the DHCP
mode before assigning the IP
address manually, the next
time power is cycled to the
drive, the drive will lose the IP
address that had been
assigned previously.
Buttons
Display