Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start - Manual (Page 5)

Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012 5
Preface
About This Publication
This quick start provides examples and procedures for integrating a Kinetix  350 drive into any
Logix5000

controllers control system over an EtherNet/IP network. The programming
examples are not complex, and offer easy solutions to verify that devices are functioning and
communicating properly.
Before Using This Publication
You can only complete the tasks described in this publication after first completing some
prequisite tasks with a Logix5000 controller. For example, before you can add a Kinetix 350
drive to an RSLogix
 5000 project, as described on page 31 , you must first create the project in a
Logix5000 controller.
For more information on how to complete these tasks with specific Logix5000 controllers, see
the Integrated Architecture

: Logix5000 Control Systems Quick Starts Quick Reference,
publication IASIMP-QR024 .
IMPORTANT This publication describes basic example tasks you can complete when using a Kinetix 350 drive over an EtherNet/IP
network. The tasks described are not the only tasks you can complete with the drive on an EtherNet/IP network. You
will likely need to complete additional tasks when using a Kinetix 350 drive in a specific Logix5000 control system.
IMPORTANT The example graphics shown in Table 1 - Required Tasks to Complete before Using This Quick Start on page 6 are for
CompactLogix

5370 L3 controllers. Depending on the Logix5000 controller you are using, the specific steps to
complete the tasks described in the table might vary.