Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start - Manual (Page 23)

Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012 23
Prepare the Kinetix 350 Drive Hardware Chapter 1
Wire the Input Power Connector
You can use a 120V AC or 240V DC power source to connect input power to the
2097-V31PR2-LM drive via the IPD connector. In this quick start, we describe how to connect a
120V AC power source to the drive.
Complete these steps to wire the IPD connector.
1. Verify the 120V AC power source is not powered.
2. Remove the IPD connector plug
from the top of the drive.
3. Remove approximately 7 mm
(0.28 in.) insulation from four
2.5 mm
2
(14 AWG)
copper wires.
4. Insert the wires from the 120V
AC power source cable into the
IPD connector positions
according to the following table.
The L2/N connector is not used when connecting input power from a 120V AC
power source.
5. Insert the connector plug into the location shown above.
Power Cable Wire Terminal
Black L1
White N
Green PE
IMPORTANT Do not connect power to the external power supply.
L2/N
L1
N
PE
Top View of Drive