Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start - Manual (Page 40)

40 Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012
Chapter 2 Add a Kinetix 350 Drive to an RSLogix 5000 Project
6. Click OK to close the Change Catalog Number dialog box.
Motor data specific to your motor appears in the Motor category.
7. Click Apply.
Motor data specific to your MPL-A310P-MJ72AA motor appears in the Motion category.
You do not need to change the parameters in the other categories to complete the tasks
described in this quick start.
8. Click OK to close the Axis Properties dialog box.
9. Save the file and download it to the controllers.
10. Verify the controller is in the Remote Run mode.