1 - prepare the kinetix 350 drive hardware, Before you begin, Chapter 1 – Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start User Manual
Page 13: Prepare the kinetix 350 drive hardware, Prepare the kinetix 350, Drive hardware, Chapter
Advertising
Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012
13
Chapter
1
Prepare the Kinetix 350 Drive Hardware
In this chapter, you learn how to complete the following tasks:
•
Mount a 2097-V31PR2-LM drive.
•
Make multiple connections, for example, power, feedback and resistor connections to
the drive.
•
Configure EtherNet/IP communication for the drive.
Before You Begin
You must complete these tasks described in
Before Using This Publication on page 5
before using
this chapter:
•
Prepare the Logix5000 control system hardware
•
•
- The tasks described in this chapter require an
EtherNet/IP network.
•
Create an RSLogix 5000 project
The example RSLogix 5000 project used in this chapter uses a
CompactLogix 5370 L3 controller.
Advertising