Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start User Manual
Page 6
6
Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012
Preface
Table 1 - Required Tasks to Complete before Using This Quick Start
Task
Description
Prepare the Logix5000
control system
hardware
Assemble the control system and connect to necessary communication networks. Some components, for
example, the Logix5000 controller and system power supply, are required. Other components, for example, a
network communication module, are optional.
These example graphics show the assembly of one Logix5000 controller.
IMPORTANT: This task does not include installation of specific hardware components, for example,
Kinetix 350 drives, used over the networks included in your application.
Prepare the computer Install necessary software on your complete. Some software, for example, RSLogix 5000 software.
2 (Rear)
1 (Front)