Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start - Manual (Page 29)

Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012 29
Prepare the Kinetix 350 Drive Hardware Chapter 1
Complete these steps to assign an IP address for your drive.
1. Press .
2. Use to access parameter IP_1.
3. Press .
4. Use to set the value for parameter IP_1.
5. Press .
6. Repeat step 1 through step 5 to change the values for the remaining IP address parameters,
that is, IP_2, IP_3 and IP_4.
7. Cycle power to the drive.
8. Apply back-up power to the drive via the BP connector.
Additional Resources
For a list of additional resources that might assist you when preparing the Kinetix 350 drive
hardware, see
page 12 .