What you need – Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start User Manual
Page 32
Advertising
![background image](/manuals/581044/32/background.png)
32
Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012
Chapter 2 Add a Kinetix 350 Drive to an RSLogix 5000 Project
•
The tasks described in Chapter 1,
Prepare the Kinetix 350 Drive Hardware on page 13
include the following:
–
–
–
–
Disable the Safe Torque-off Feature
–
Wire the Back-up Power Connector
–
Wire the Input Power Connector
–
Wire the Motor Power Connector
–
Apply the Motor Cable Shield Clamp
–
Wire the Motor Feedback Connector
–
Connect the Kinetix 350 Drive to the EtherNet/IP Network
–
Assign an IP Address to the Kinetix 350 Drive
What You Need
You need RSLogix 5000 software to complete the tasks described in this chapter.
Advertising