Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start - Manual (Page 16)

16 Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012
Chapter 1 Prepare the Kinetix 350 Drive Hardware
Prepare the Panel
You must install the 2097-V31PR2-LM drive on a grounded panel. This quick start assumes you
installed a panel when you fulfilled the prerequisite task of installing the Logix5000 control
system hardware:
• If you have already installed a painted, grounded panel, move to section Mount the Kinetix
350 Drive .
• If you have not already installed a painted, grounded panel, do so before proceeding to the
next section.
For more information on properly installing a panel that you can use with a Kinetix 350
drive, see the Kinetix 350 Single-axis EtherNet/IP Servo Drives User Manual,
publication
2097-UM002 .
Mount the Kinetix 350 Drive
1. Verify that you have at least the
minimum clearance to mount your
2097-V31PR2-LM drive on
the panel.
25.0 mm (1.0 in.)
3 mm (0.12 in.) 3 mm (0.12 in.)
25.0 mm (1.0 in.)