Rockwell Automation 20B PowerFlex 70, PowerFlex 700 Reference Manual - Manual (Page 76)

Digital Inputs
76 Rockwell Automation Publication PFLEX-RM001H-EN-P - June 2013
The drive will not jog while running or while the “Stop - Clear Faults” input is
open. Start has precedence.
The terminal block bit must be set in the [ Jog Mask] and [Logic Mask]
parameters in order for the terminal block to cause the drive to jog using this
input function.
•
Jog Forward, Jog Reverse
An open to closed transition on one input or both inputs while drive is
stopped will cause the drive to jog unless the “Stop - Clear Faults” input
function is configured and open. The table below describes the actions taken
by the drive in response to various states of these input functions.
If one of these input functions is configured and the other one isn’t, the above
description still applies, but the unconfigured input function should be
considered permanently open.
The drive will not jog while drive is running or while “Stop - Clear Faults”
input is open. Start has precedence
.
The terminal block bit must be set in the [ Jog Mask], [Direction Mask], and
[Logic Mask] parameters in order for the terminal block to cause the drive to
jog using these input functions.
Important: Direction control is an “Exclusive Ownership” function (see
Owners). This means that only one control device (terminal
block, DPI device, HIM, etc.) at a time is allowed to control
direction at a time. The terminal block must become direction
“owner” before it can be used to control direction. If another
device is currently the direction owner (as indicated by
[Direction Owner]), it will not be possible to jog the drive or
change direction by using the terminal block digital inputs
programmed for both Run and Direction control (i.e. Run/
Fwd).
If another device is not currently the direction owner (as indicated by
[Direction Owner]) and the terminal block bit is set in the [Direction Mask]
!
ATTENTION: If a normal drive start command is received while the
drive is jogging, the drive will switch from jog mode to run mode. The
drive will not stop, but may change speed and/or change direction.
Jog Forward Jog Reverse Action
Open Open Drive will stop if already jogging, but can be started by other means. Terminal
block relinquishes direction ownership.
Open Closed Drive jogs in reverse direction. Terminal block takes direction ownership.
Closed Open Drive jogs in forward direction. Terminal block takes direction ownership.
Closed Closed Drive continues to jog in current direction, but terminal block maintains
direction ownership.
!
ATTENTION: If a normal drive start command is received while the
drive is jogging, the drive will switch from jog mode to run mode. The
drive will not stop, but may change speed and/or change direction.