Rockwell Automation SD3000 Drive Configuration, Programming - Manual (Page 2)

The information in the user’s manual is subject to change without notice.
ONLY QUALlFlED ELECTRICAL PERSONNEL FAMILIAR WITH THE CONSTRUCTION
OPERATION OF THIS EQUIPMENT AND THE HAZARDS INVOLVED SHOULD INSTALL, ADJUST,
OPERATE, OR SERVICE THIS EQUIPMENT. READ AND UNDERSTAND THIS MANUAL AND OTHER
APPLICABLE MANUALS IN THEIR ENTIRETY BEFORE PROCEEDING. FAILURE TO OBSERVE THIS
PRECAUTION COULD RESULT IN SEVERE BODILY INJURY OR LOSS OF LIFE.
W A R N I N G
THE USER MUST PROVIDE AN EXTERNAL, HARDWIRED EMERGENCY STOP CIRCUIT OUTSIDE OF
THE CONTROLLER CIRCUITRY THIS CIRCUIT MUST DISABLE THE SYSTEM IN CASE OF
IMPROPER OPERATION. UNCONTROLLED MACHINE OPERATION MAY RESULT IF THIS
PROCEDURE IS NOT FOLLOWED. FAILURE TO OBSERVE THIS PRECAUTION COULD RESULT IN
BODILY INJURY
I
W A R N I N G I
ONLY QUALIFIED RELIANCE PERSONNEL OR OTHER TRAINED PERSONNEL WHO UNDERSTAND
THE POTENTIAL HAZARDS INVOLVED MAY MAKE MODIFICATIONS TO THE RACK
CONFIGURATION, VARIABLE CONFIGURATION, AND APPLICATION TASKS. ANY MODIFICATIONS
MAY RESULT IN UNCONTROLLED MACHINE OPERATION. FAILURE TO OBSERVE THESE
PRECAUTIONS COULD RESULT IN DAMAGE TO EQUIPMENT AND BODILY INJURY.
I
W A R N I N G I
REGISTERS AND BITS IN THE UDC MODULE THAT ARE DESCRIBED AS “READ ONLY” OR FOR
“SYSTEM USE ONLY” MUST NOT BE WRITTEN TO BY THE USER. WRITING TO THESE REGISTERS
AND BITS MAY RESULT IN IMPROPER SYSTEM OPERATION. FAILURE TO OBSERVE THIS
PRECAUTION COULD RESULT IN BODILY INJURY
CAUTION: Electronic motor overload protection must be provided for each motor in a Distributed Power
d r i v e a p p l i c a t i o n t o p r o t e c t t h e m o t o r a g a i n s t e x c e s s i v e h e a t c a u s e d b y h i g h c u r r e n t s . T h i s p r o t e c t i o n c a n b e
p r o v i d e d b y e i t h e r t h e T H E R M A L O V E R L O A D s o f t w a r e b l o c k o r a n e x t e r n a l h a r d w a r e d e v i c e . A p p l i c a t i o n s i n
which a single power module is controlling multiple motors cannot use the THERMAL OVERLOAD software
b l o c k a n d m u s t u s e a n e x t e r n a l h a r d w a r e d e v i c e o r d e v i c e s t o p r o v i d e t h i s p r o t e c t i o n . F a i l u r e t o o b s e r v e t h i s
precaution could result in damage to, or destruction of, the equipment.
EthernetTM is a trademark of Xerox Corporation.
WindowsTM ’
IS a trademark of Microsoft Corporation.
ReSourceTM ’ IS a trademark of Reliance Electric Company or its subsidiaries.
Reliance* and AutoMax@ are registered trademarks of Reliance Electric Company or its subsidiaries.
Copyright Reliance Electric Industrial Company 1995.