EVCO c-pro nano CHIL - Manual (Page 97)

C-PRO NANO CHIL AND C-PRO MICRO CHIL – APPLICATION MANUAL
Pag. 97
By selecting these units, default values for parameters PC11=2, PH44=1 and PH45=1 are
automatically set, while a “0” value is set for all input/output position parameters not specified in
this configuration.
(*¹) Digital input derived from analogue input (parameter PH44).
(*²) Digital input derived from analogue input (parameter PH45).
CAUTION! When the machine type is changed (by modifying parameter PG00 or PG01), it is
necessary to switch OFF and then back ON the plant, to enable the unit to reconfigure itself
correctly; to allow the card to assign all affected parameters, it is advisable to wait for a few
seconds (3 seconds are more than ample time), before interrupting the unit’s power supply.