Connecting machine, Running machine, Running machine without foot speed controiier – SINGER XL100 Quantum User Manual
Page 11: Threading machine ,13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting Machine
Push foot speed controller plug into lower receptacle at right
end of machine.
Push power cord plug
O
into upper receptacle at right end of
machine. Plug 0 into electric outlet.
NOTE:
If upper LCD window or lower LCD touch-screen is too bright or dark to see the stitch patterns, adjust LCD brightness
control (see page 15).
Running Machine
Power/light switch.
- When ‘T’ side of power switch is pressed machine will be turned on.
- When “O” side of power switch is pressed machine will be turned off.
Note:
Power switch must be on before light switch will operate.
To run machine press foot speed controller. The harder you press, the faster machine will
sew.
To stop machine, remove foot from controller.
Running machine without foot speed controiier
Foot control must be unplugged for start/stop button and sewing speed lever to operate.
Start/stop button
One press on button starts
machine, and another press
stops machine.
Sewing speed lever
Sliding lever sets desired
sewing speed.
Note:
#1.When foot speed controller is plugged In, start/stop button can only be used to stop machine.
#2. When foot speed controller Is plugged in, sewing speed lever will not operate.