SINGER XL100 Quantum - Manual (Page 29)

Automatic buttonhole steps
12 3 4
! I
i
^
\
► 1 J
^ ^
>
1
: ' ^ :
i.
1 <
*• 1 *
:
I
I
0
1 ^
r V 1
Tacking stitch
At end of buttonhole
machine will sew a
tacking stitch, then stop
Tacking stitch automatically.
Purl stitch Buttonholes
The bartack buttonholes and the keyhole
buttonhole can be used for purl stitch effect.
Select desired buttonhole and press 2-color
key CM .
• Finished appearance resembles a hand
sewn buttonhole.
7
Position material.
8
Lower buttonhole foot.
9
Lower buttonhole lever.
and underplate. of needle hole in foot.
If problem indicator
comes on, buttonhole
lever has not been
lowered correctly.
When buttonhole
lever is fully lowered
problem indicator will
go off.
Attempting to sew without lowering the buttonhole lever, will cause problem indicator to flash on and off, and machine will not
start.
If buttonhole length is set wrong, or needle or bobbin thread runs out, restart buttonhole from beginning by pressing buttonhole
stitch pattern selection button once.
10 Begin sewing. 11 Press thread cutter button.
threads.
Open completed buttonhole, using seam
12 ripper.
ii Bartacked
Ü buttonholes
Straight pin
Ì
Seam ripper
ft Keyhole i l Eyelet
y buttonhole S — ^ punch
Cut middle of buttonhole open using seam ripper,
being careful not to cut threads.
It is advisable to place a straight pin at end of
buttonhole to help prevent overcutting.
Use eyelet punch to cut out round portion of
keyhole buttonhole. It is advisable to place fabric
on old piece of wood.
27